JeepAndBass Tips:  To get the most out of this amp you should upgrade your battery under the hood, add four additional batteries in the rear, use a minimum of three 0 awg runs of wire from front to rear, and two upgraded alternators! 
 
The Pitbull 20k competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It’s built with the best of the Best parts from the Mosfets to the Large Tiffany Jacks.
 
It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.
 
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs
 
Specifications 
RMS: 7,500Wx1- @ 4ohm - 14.4V
         13,00Wx1- @ 2ohm - 14.4V
        20,000Wx1- @ 1ohm - 14.4V
Imput Sensitivity: 6V~0.2V 
Low/High Filter: 35Hz~250Hz
Subsonic FIlter: 10Hz~50Hz
Bass Boost: 0~9dB 
Frequency Response: 15Hz-270Hz 
Signal to Noise Ratio: 85dB 
Damping Factor: 300< 
Efficiency @ 4ohm: Over 90% 
THD @ 4ohm: Less than 0.1% 
Fuse Rateing: 2,000 Amps 
Power Terminal Size: Tripple 0 Guage 
 
Length: 37.75"
Width: 11.5" 
Hight: 2.6"